![]() I got the Maktec cheap off eBay (150 bucks from memory) I should have checked one out at bunnings and I probably wouldn't have bought it. ![]() I compensate by putting a small amount of lateral pressure on the winder as I wind it. The fine adjustment on the Maktec is a bit dodgy when reducing the depth of cut. Lots of grunt, very well made, very smooth plunge, a joy to use PS in my humble opinion the 36 are two of the most well made routers ever. I was tempted by the maktec given bunnies had them reduced down to $199 but changed my mind because of the sloppy fine adjustment. (I am expecting one of these in the mail soon, will write a report on how good they are). I suspect given that they are made in china that they come from the same factory as the copies that are been sold on ebay. ![]() Out of interest is your maktecs fine adjustment up to scratch? All the demos I have tried seem to get stuck, not as good as the makita 3612. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |